Frequently, the bar code printer ten fault _ printing devices

In the use of bar code printers, bar code printers, more or less there will be a little bit small fault, whenever a failure will greatly affect our work efficiency, so we when it is necessary to understand the bar code printer bar code printing prone to failure and the corresponding solutions, in order to quickly solve fault, restore normal product operation. 1, undetectable paper when printed. Reasons: 1) Sensor (2) Label paper. Can change another kind of paper label printing, look to whether normal, if normal, print a few protracted war in just can't measure up to the label of paper, to test the paper printing. Such as is not normal, first clean the dirt on the surface of the sensor, if not only replace the sensor test paper again. 2, when the printing is clear, while the fuzzy. Reason: the printer pressure imbalance. The print head screw knob are adjustable pressure, the print is not clear that one side pressure adjustable bigger is ok. In addition some machines with only one screw knob adjustment, but can move freely, then put it into is not clear that a move to increase pressure with respect to OK. 3, always keep the tag changes when not, according to save there is a warning dialog box, according to the software after shut down. Reason: the user modify directly on the label changes caused by wrong operation. Can be modified according to the right to modify the way to modify the double-click to modify content, you write when the original layout on the dialog box of modification, does not allow directly in the label on modification. This modified is back to normal. 4, small printer in the print label will not reach the designated position, total slants upwards or downwards partial printing content. Reason: the tag is too small, sensors are difficult to sensor to the paper. Label generally high at least more than 10 more than just good positioning, otherwise will be to offset Settings TAB. In the tag set, the label set to higher than the actual label tall a 5 mm or so, and then according to the specific migration situation to offset Settings TAB. 5, when printing labels, there are always some words can't print it out. Reason: the print head is dirty, layout is wrong. Cleaning the print head; In addition whether in typesetting to overlap the printed word, recomposition. 6, printer when printing always shows no paper or carbon belt. Reason: you run out of paper or carbon belt is wrong; Sent wrong operation command. Check the paper or carbon belt is correct; Parameters set on the machine, then use printing software for printing after the correct layout Settings. 7, print is not clear when print it, the ribbon broken reasons: printer carbon belt shaft failure. Carbon belt machine shaft tension is too tight, adjust the printer carbon belt shaft under strain. 8, the new file can be normal print, but can't open the old file, unable to print. Reason: network printing, permissions error. Print, whether on the Internet has opened this file, if you open, must first turn off can be opened on another computer. Then detect network access problems. 9, print content when the print is not completely. Reason: printing software and driver version is too low. Install the new version of the barcode software and drivers. 10, barcode software cannot be typography. Reason: the software not installed or computer problems. Reinstall the software, if not yet, may be computer got a virus and anti-virus, please. Not again, please reinstall the operating system. Above is the entire content of this article, if you want to more information of bar code equipment, welcome by WeChat, website and telephone to consult with our company, we will wholeheartedly for you to answer each question, make you satisfied.